ENVI-GEL 365
ENVI – GEL 365 is the most advance insulation and solar reflectance coating system that can be applied on both on inside and outside to reduce heat and cold loss. The product is a mixture of safe and natural ingredients with no flammable solvent.
The typical coating thickness is between 0.3 mm to 5 mm depending on applications and desired outcomes. The application may be brush, roller and sprayed and since it is water based and dust free, it may be applied even indoors.
| Time | H Temp. Under roof (C) | C ENVI – GEL 365 coated (C) | Reduction | Percentage. |
|---|---|---|---|---|
| 9 am. | 43.2 | 36.3 | 6.9 | -15.97% |
| 11 am. | 55 | 42.5 | -12.5 | -22.73% |
| 1 pm. | 56.4 | 44.6 | -11.8 | -20.92% |
| 3 pm. | 49.7 | 40.5 | -9.2 | -18.51% |
| 5 pm. | 48.4 | 40 | -8.4 | -17.36% |
ENVI – GEL 365 TECHNICAL PROPERTIES
- Safe and Eco Friendly formulation
- Zero Flammable Solvent
- Dust Free
- Usage Temperature -50 C to + 120 C
- Applied by conventional brush, roller and spray applications
- Electric based paint sprayers are acceptable since the product do not pose ignition and explosive risks
- Varying thickness between 0.3 mm to 5 mm to achieve desired conservation outcomes
- Reflects up to 91% solar radiation
- Thickness can be build up to achieve 100% conservation and zero losses
- Minimum service life when applied outdoors under direct sunlight – 5 Years
- More than 10 years service life when not exposed to sunlight, UV or Temperature above + 80 C
- Act as a waterproof but yet breathable barrier to prevent water ingress
- Repairs corroded and leaking roofs and conserve energy at the same time
- Repels water, fungi and algae resistant
- Safe to use indoors as an aesthetic paint with insulation properties to reduce heat and cold loss
- May be used on zinc, aluminum, concrete and masonry
- Apply directly on existing paint – Removal of old paint is not needed
Seals leaks and stop rusting roofs
Stop annoying leaks at roof screws
Save your costly false ceiling
Stop algae and unwanted growth
Anti Mildew and Mould
Cut electrical bills by half
| Applications | Recommended thickness | |
|---|---|---|
| Residential and Commercial Establishments (Hot Climate) |
|
0.3 mm on roofs and vertical surfaces will generally bring the indoor air temperature to 28 C even on a hot day at 38 C |
| Residential and Commercial Establishments (Cold Climate) |
|
2 mm to be applied on internal walls and ceilings to achieve best results in heat conservation. Product is safe and dust free and may be applied directly on existing paint work |
| Cold Storage Containers |
|
0.3 mm on external of container to reduce solar heat conductivity. Reflects away up to 91% of solar radiation reducing heat build up. |
| Solar Battery Energy Storage |
|
0.3 mm on external of container to reduce solar heat conductivity. Reflects away up to 91% of solar radiation reducing heat build up. Dual side solar panel will be optimised |
| Pipelines and Tanks |
|
Apply at least 5 mm on air con and chiller piping to insulate 18 C (Up to 90% efficiency) For process piping/tanks to prevent Corrosion under insulation (sweating pipelines) – 3 mm over 22 C to prevent condensation For hot process piping and tanks, typical thickness of 5 mm is needed to conserve 80 C (90% efficiency) |